A mouse can fit through a hole about a quarter inch wide. That is the CDC's figure, roughly the width of a pencil. Rats need a bigger opening, but not by as much as most people think, and they can chew a small gap larger.
That is why mouse problems are so hard to stop without a careful look at the whole house. The gaps are small, they are often hidden behind appliances or siding, and there are a lot of them in an older Seattle home. This article covers where they hide and which materials close them for good.
Why such a small hole is enough
A mouse's body is narrow and flexible, and if its head fits through a gap, the rest usually follows. A quarter inch is smaller than most people picture. Hold a pencil up to the gap around your gas line or under your garage door corner and you may find several openings that size.
Rats need more room, but they are strong chewers. A rat can widen a gap in wood, plastic, rubber, soft aluminum or foam. A hole that starts too small for a rat may not stay that way.
For sealing, the rule of thumb is simple: if a pencil fits, a mouse can get in.
Where the gaps are in a Seattle house
The CDC lists the places to check inside and out. In Seattle homes, these are the usual suspects:
- Around the gas line, water main and sewer cleanout where they enter the house.
- The dryer vent, bath fan vent and kitchen hood vent, where the hood flap is broken or missing.
- The sill plate, where the wood frame sits on the concrete foundation, especially on older houses that have settled.
- Crawl space vents with rusted screens.
- Garage door corners and worn bottom seals.
- Gaps where siding meets the foundation, and where an addition or porch meets the house.
- Behind the dishwasher, stove and fridge, where pipes and wires come through the wall.
- Under sinks, around supply lines and drain pipes.
- Attic gable and soffit vents, and gaps at the roofline.
Cable, internet and solar installs often add new holes through siding that never get sealed properly.
Want a technician to take a look?
Call (206) 385-0133Which materials work
The CDC recommends filling small holes with steel wool and putting caulk around it to keep it in place. For large holes, it lists lath screen, metal, cement, hardware cloth or metal sheeting.
For Seattle houses, that usually means:
- Steel wool or copper mesh packed tightly into gaps around pipes, then sealed with caulk. Copper mesh does not rust, which helps in damp crawl spaces and outside walls.
- Galvanized hardware cloth (quarter-inch mesh or smaller) over vents.
- Metal flashing or sheet metal over larger gaps at the sill or foundation.
- Mortar or concrete patch for holes in foundations.
- Door sweeps with a metal or dense brush edge, and garage door corner seals.
Rust matters in this climate. Plain steel wool in a wet spot rusts and stains. Use copper mesh or stainless options outside and in damp crawl spaces.
Steel wool vs copper mesh vs foam
Steel wool is cheap and works well indoors, under sinks and behind appliances. It rusts when wet, so it is a poor choice outdoors in Seattle.
Copper mesh costs more, does not rust and is easy to pack into gaps. It is a good choice around exterior pipes and in crawl spaces.
Expanding foam is easy to use and fills odd shapes, but rodents chew through it. Use it only as a filler behind or around metal, never alone.
Caulk holds mesh in place and seals air gaps, but on its own it is not a rodent barrier.
Whatever you use, pack it tight. Loose steel wool can be pulled out.
Seal at the right time
If mice are already inside, sealing every gap at once can trap them in the walls. The usual approach:
- Seal the outside entry points first.
- Set snap traps inside along walls and at the spots where mice come out, like under sinks.
- Once catches stop for a week, seal the inside openings too.
If you seal inside gaps first, mice may die in the walls, and the smell can last weeks. See dead rodent smell.
Want a technician to take a look?
Call (206) 385-0133When to get help
Most homeowners can seal pipe gaps under sinks and behind appliances. Crawl space vents, sill gaps, rooflines and garage doors are harder, especially on a tall or hillside house.
If you keep catching mice after sealing what you can find, there is a gap you missed. A technician who does rodent exclusion will check the whole house, inside and out. If you have deer mice near a greenbelt, also read deer mice before cleaning up.